ANT SWR Antenna Analyzer Meter For Ham Radio Hobbists + PC software

Description

ANT SWR Antenna Analyzer For Ham Radio Hobbists
Battery not included! The main board is all welded and tested, and the casing is completely assembled. After receiving it, it can be installed with a 9.6V battery pack. Red and black power supply lines have been reserved internally. If there is no wiring capacity, please do not purchase.
FEATURES:
This is a SWR Analyzer for ham hobbists.
User manual is to be sent by email upon request.
Frequency Generation & Control: 1 - 60 Mhz
Source impedance: 50 Ohms
Stability: +/- 100 ppm
Spectral Purity: Harmonics down >- TBD dB beyond 60 MHz
Step Size: User configurable increments of 100 Hz, 1 kHz, 10 kHz, and 100 kHz
Usable Measurement Range:SWR: 1.0 to 9.99
Impedance: approx. 5 to 2000 ohms
RF Output: Adjustable: 2.0 Volts pp (typ)
Power supply: Powerd by External: 12 to 15 Volts DC, 500mA
Controls: Pushbuttons (5): "Mode", "Band", "Config", "Scan", "Up", "Down"
Switch: "Power On"
Connectors: RF Out: BNC
USB: Mini-B receptacle
External power: 2.1mm Power Jack (center pin positive)
Applications:
Measure antenna electrical parameters: SWR, impedance (resistance +
reactance), capacitance, inductance
Measure feedpoint impedance
Measure ground loss
Adjust antenna tuners and determine loss
Measure inductors and capacitors
Measure coax transmission line (SWR, length, velocity factor, approximate Q
and loss, resonant frequency, and impedance)
Measure and determine optimum settings for tuning stubs: SWR, approximate
Q, resonant frequency, bandwidth, impedance
Determine characteristic impedance of transmission line
Determine length of ? and ? wave phasing lines
Coaxial Cable Loss
Determine antenna tuner loss
Measure balun loss
Measure inductor Q
Estimate quartz crystal parameters
Measure magnetic loop resonance and SWR
Operation button definitions:
Mode: selects operation mode: impedance(default), complex impedance, capacitance, and inducatance
BAND: select band from any of the available bands: 160M to 6M
SCAN: pressing this control initiates a scan of frequencies of the selected BAND. Scan exits to impedance mode showing the 2:1 bandwidth and the resonant point o the antenna
CAN(up): increase frequency and used to cancel operation for CONFIG menu
VAL(down): decrease frequency and used to validate operation for CONFIG menu
Package
SWR Analyzer (
Batteries and other accessories not included
)